englishAbout UsCataloguePricesContactsNewsOrderLinks
Catalogue
 
 Antifriction graphite-fluoroplastic materials


AMC-3 grade material
Is used to manufacture the parts of face thickenings operating both in the water and in the air.

Size of moulds, mm
  Diameter or cross section   Length or hight
  Rated   Tolerance   Rated   Tolerance
  260   5   150   25
  100400   5   150   30

It is possible upon agreement between a factory-consumer and the factory-manufacturer to supply moulds of other sizes within the scope of maximum ones.

Phisico-mechanical properties
  Dencity, kg/m3 (g/cm3), min.   1780 (1.78)
  Compression strength, MPa (kgc/cm3), min.   79.7 (812)

For the parts made of AMC-3 material it is recommended to use the bronze -5-5-5 and the steel -985 and stainless steels as the countershank material with the smoothness of not less than N 8-N 9. Permissible working temperature upon exploitation of products made of AMC-3 material should be within the limit of 60 to +200 C. It is not allowed to apply products made of AMC-3 material in direct contact with food products.
  About Us  Catalogue  Prices  Contacts  News  Order  Links
Rambler's Top100